Electropermanent Lifting Magnet EPMH

The electropermanent load lifting magnets from the EMPH series are suitable for the lifting and transportation of individual slabs and unprocessed blocks. These magnets are used to handle loads with a large air gap or with scaled surface.

Only a 400V rated current must be provided to use these devices and they are then immediately ready for use.

Through short electrical impulses within seconds, the EPMH from ASSFALG are automatically switched on or manually with the push of a button. No electricity flows during load transport and nevertheless, the workpiece is as securely clamped as with a permanent load lifting magnet.

Through the impulse current control, the EPMH load lifting magnets do not use much energy. The effectiveness and efficiency can be seen on the one hand in the reduction of operating costs and on the other hand in a saving of time.

The electropermanent load lifting magnets from ASSFALG are particularly efficient through the pick-up mechanism, which works almost like a remote control. The magnet is automatically switched on with the complete relief of the crane chain, while a magnet sensor near the magnet eyelet acts as a proximity switch and triggers the switch impulse (ON/OFF pick-up mechanism). This also reduces work steps and therefore costs as well.

If you would not like the automatic mechanism, you still have the possibility to switch the magnets either directly on the device or with an optionally available remote control.