Electropermanent Magnetic Chuck Doublemag

Whether while milling (rough and finish machining), drilling, sawing, welding or assembling, the EPM modules or module systems offer a large selection of clamping options, for example, to clamp during edge milling or deburring (without mechanical clamping equipment) or for the simple and quick fastening of workpieces during assembly. Workpieces can be easily and quickly fastened with the Doublemag magnet clamping elements.

Through the use of pole extensions, any unevenness on the workpiece can be compensated for and a deformation of the workpiece can be prevented. Using pole extensions, plane-parallelism of up to 0.01 mm is possible on the workpiece. The processing runs without vibration and an even distribution of holding force is guaranteed throughout the entire ferrous clamping surface. Several Doublemags can be combined to process large parts.

The Doublemag magnet modules have a solid steel surface and are therefore significantly more resistant than conventional plates with epoxy resin against hot chips, coolant and other processing influences.

In the event of a power failure or a cable break of the control line, the workpiece will remain clamped on the Doublemag modules with complete holding force. An accidental loosening of the workpieces through malfunction is also ruled out through the two-button operation both on the controller and on the cable remote control.