Electropermanent Lifting Magnet EPMM

The EPMM electropermanent load lifting magnets are used where there is a frequent change of workpieces due to the very short switching times. Only a 230V rated current, depending on magnet with 230V or 400V, must be provided to use these devices and they are then immediately ready for use.

Through electrical impulses within seconds, the EPMM from ASSFALG is automatically switched on or manually with the push of a button. No electricity flows during load transport and nevertheless, the workpiece is as securely clamped as with a permanent load lifting magnet.

The electro permanent battery lifting magnet EPMM can be used in single mode as well as on magnet traverses and is an interesting alternative for 3-shift operation. With the tip function (inching), even stacked sheets can be separated starting with a thickness of 4 mm.

Through the impulse current control, the EPMM load lifting magnets do not use much energy. The effectiveness and efficiency can be seen on the one hand in the reduction of operating costs and on the other hand in a saving of time.
The electropermanent load lifting magnets from ASSFALG are particularly efficient through the pick-up mechanism, which works almost like a remote control. The magnet is automatically switched on with the complete relief of the crane chain, while a magnet sensor near the magnet eyelet acts as a proximity switch and triggers the switch impulse (ON/OFF pick-up mechanism). This also reduces work steps and therefore costs as well.

If you would not like the automatic mechanism, you still have the possibility to switch the magnets either directly on the device or with an optionally available remote control.

Our models EPMM 2000 and above are now equipped with a 360° visible LED status indicator that clearly signals the magnet status.
It shows whether the magnet is magnetised (green) or demagnetised (red).

Upon customer request, special pole shoes can also be made for the transportation of round workpieces.